kvr13s9s6/2 2gb 1rx16 256m x 64-bit pc3-10600 cl9 204-pin sodimm description this document describes valueram's 256m x 64-bit (2gb) ddr3-1333 cl9 sdram (synchronous dram) 1rx16, memory module, based on four 256m x 16-bit fbga components. the spd is programmed to jedec standard latency ddr3-1333 timing of 9-9-9 at 1.5v. this 204-pin sodimm uses gold contact fingers. the electrical and mechanical specifications are as follows: features ? jedec standard 1.5v (1.425v ~1.575v) power supply ? vddq = 1.5v (1.425v ~ 1.575v) ? 667mhz fck for 1333mb/sec/pin ? 8 independent internal bank ? programmable cas latency: 9, 8, 7, 6, 5 ? programmable additive latency: 0, cl - 2, or cl - 1 clock ? 8-bit pre-fetch ? burst length: 8 (interleave without any limit, sequential with starting address ?000? only), 4 with tccd = 4 which does not allow seamless read or write [either on the fly using a12 or mrs] ? bi-directional differential data strobe ? internal(self) calibration : internal self calibration through zq pin (rzq : 240 ohm 1%) ? on die termination using odt pin ? average refresh period 7.8us at lower than tcase 85c, 3.9us at 85c < tcase < 95c ? asynchronous reset ? pcb : height 1.180? (30.00mm), single sided component document no. valueram1371-001.a00 11/12/13 page 1 memory module speci cations specifications cl(idd) 9 cycles row cycle time (trcmin) 49.125ns (min.) refresh to active/refresh 260ns (min.) command time (trfcmin) row active time (trasmin) 36ns (min.) maximum operating power 1.050 w* ul rating 94 v - 0 operating temperature 0 o c to 85 o c storage temperature -55 o c to +100 o c *power will vary depending on the sdram used. continued >>
module dimensions: document no. valueram1371-001.a00 page 2
|