i/q mixer / modulator communications band lo (ghz) 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 rf (ghz) 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 3.0-6.0 if (mhz) dc-100 dc-300 dc-300 dc-300 dc-300 dc-300 dc-300 dc-300 dc-300 min 20 db 25 db 20 db typical 5.5 db 6.5 db 28 db 0.1 db 2.5 deg 31 db 30 db 50 db 40 db +5 dbm +8 dbm +12 dbm +14 dbm +17 dbm +21 dbm +10 dbm +13 dbm +17 dbm max 7.5 db 8.5 db miq34 miq36 miq37 miq34 miq36 miq37 miq34 miq36 miq37 conditions electrical specifications (1) : parameter ssb conversion loss: (2) (3) image rejection side- band suppression: (4) amplitude match phase match isolation lo to rf: lo to i/q: rf to i/q: i/q to rf: input 1 db compression point: input third order intercept point: lo power: (5) model MIQ3XMS-3 rf 3.0 to 6.0 ghz notes: 1. specifications are guaranteed when tested as a downconverter in a 50 ohm system at +25 ? c with the nominal lo power. specifications indicated as typical are not guaranteed. 2. noise figure is typically within 0.5 db of conversion loss for if frequencies greater than 10 mhz. 3. conversion loss typically degrades less than 0.5 db at +100 ? c and improves less than 0.5 db at -55 ? c. conversion loss is the combined value. 4. measured with an if quadrature hybrid whose amplitude and phase errors are 0.5 db and 3 degrees maximum. 5. usable lo drives are up to 2 db below to 3 db above nominal. 6. see application notes m112, for aid in selecting the outline and for mounting and installation information. lo power 4 = +10 dbm 6 = +13 dbm 7 = +17 dbm typical performance at 25 ? c all dimensions are in inches and [mm]. outline: msq7 MIQ3XMS-3 specifications model MIQ3XMS-3 spectrum microwave 2144 franklin drive n.e. palm bay, fl 32905 ph (888) 553-7531 fax (888) 553-7532 spectrum microwave 2707 black lake place philadelphia, pa 19154 ph (215) 464-4000 fax (215) 464-4001 www.spectrummicrowave.com revision b 8/08/11
|