 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| MIG400Q2CMB1X MITSUBISHI SEMICONDUCTOR MIG400Q2CMB1X (1200V/400A 2in1) High Power Switching Applications Motor Control Applications * * * * * * Integrates inverter power circuits and control circuits (IGBT drive unit, units for protection against short-circuit current, overcurrent, undervoltage and overtemperature) into a single package. The electrodes are isolated from the case. Low thermal resistance VCE (sat) = 2.4 V (typ.) UL recognized: File No.E87989 Weight: 380 g (typ.) Equivalent Circuit 1 2 3 4 5 6 7 8 FO GND IN VD FO GND IN VD GND VS OUT GND VS OUT E2 C2/E1 1. 5. FO (L) FO (H) 2. 6. GND (L) GND (H) 3. 7. IN (L) IN (H) C1 4. 8. VD (L) VD (H) 2004-10-01 1/9 MIG400Q2CMB1X Package Dimensions Unit: mm 1. 5. FO (L) FO (H) 2. 6. GND (L) GND (H) 3. 7. IN (L) IN (H) 4. 8. VD (L) VD (H) 2004-10-01 2/9 MIG400Q2CMB1X Signal Terminal Layout Unit: mm 1. 5. FO (L) FO (H) 2. 6. GND (L) GND (H) 3. 7. IN (L) IN (H) 4. 8. VD (L) VD (H) 2004-10-01 3/9 MIG400Q2CMB1X Maximum Ratings (Tj = 25C) Stage Supply voltage Collector-emitter voltage Inverter Collector current Forward current Collector power dissipation Junction temperature Control supply voltage Control Input voltage Fault output voltage Fault output current Operating temperature Storage temperature Module Isolation voltage Screw torque (terminal) Screw torque (mounting) AC 1 min M6 M5 Tc = 25C, DC Tc = 25C, DC Tc = 25C VD-GND terminal IN-GND terminal FO-GND terminal FO sink current Characteristics Condition P-N power terminal Symbol VCC VCES IC IF PC Tj VD VIN VFO IFO Rating 900 1200 400 400 3780 150 20 20 20 10 -20~+100 -40~+125 2500 3 3 Unit V V A A W C V V V mA C C V Nm Nm Tc Tstg VISO Electrical Characteristics 1. Inverter stage Characteristics Collector cut-off current Symbol ICEX Test Condition VCE = 1200 V VD = 15 V IC = 400 A VIN = 15 V 0 V Tj = 25C Tj = 125C Tj = 25C Tj = 125C Min VCC = 600 V, IC = 400 A VD = 15 V, VIN = 15 V 0 V Tj = 25C, Inductive load (Note 1) Typ. 2.4 2.8 2.4 2.0 0.5 0.3 1.6 0.3 Max 1 10 2.8 2.8 3.0 2.5 s V V Unit mA Collector-emitter saturation voltage Forward voltage VCE (sat) VF ton tc (on) IF = 400 A, Tj = 25C Switching time trr toff tc (off) Note 1: Switching time test circuit & timing chart 2004-10-01 4/9 MIG400Q2CMB1X 2. Control stage (Tj = 25C) Characteristics Control circuit current Input on signal voltage Input off signal voltage Protection Fault output current Normal Overcurrent protection trip level Short-circuit protection trip level Overcurrent cut-off time Overtemperature protection Control supply under voltage protection Fault output pulse width Trip level Reset level Trip level Reset level High side Low side Symbol ID (H) ID (L) VIN (on) VIN (off) IFO (on) IFO (off) OC SC toff (OC) OT OTr UV UVr tFO VD = 15 V VD = 15 V Test Condition Min 1.4 2.2 8 640 640 110 11.0 12.0 1 Typ. 13 13 1.6 2.5 10 5 118 98 12.0 12.5 2 Max 17 17 1.8 2.8 12 mA 0.1 125 12.5 13.0 3 ms A A s C V Unit mA VD = 15 V VD = 15 V VD = 15 V, Tj < 125C = VD = 15 V, Tj < 125C = VD = 15 V Case temperature V 3. Thermal resistance (Tc = 25C) Characteristics Junction to case thermal resistance Case to fin thermal resistance Symbol Rth (j-c) Rth (c-f) IGBT FRD Compound is applied Test Condition Min Typ. 0.013 Max 0.033 0.068 C/W Unit C/W 2004-10-01 5/9 MIG400Q2CMB1X Switching Time Test Circuit Intelligent power module TLP559 (IGM) VD 0.1 F 15 k OUT IN 15 V 68 F GND VS C1 GND C2/E1 VCC VD IF = 16 mA PG 15 V 68 F GND 0.1 F 15 k OUT IN VS E2 GND Timing Chart Input pulse 15 V VIN Waveform 0 2.5 V 1.6 V 90% Irr IC Waveform Irr 90% trr 20% Irr VCE Waveform 10% toff 10% tc (off) 10% ton 10% tc (on) 2004-10-01 6/9 MIG400Q2CMB1X 4. Recommended conditions for application Characteristics Supply voltage Control supply voltage Carrier frequency Dead time Symbol VCC VD fc tdead Test Condition P-N power terminal VD-GND signal terminal PWM control Switching time test circuit (Note 2) Min 13.5 5 Typ. 600 15 Max 800 16.5 20 Unit V V kHz s Note 2: The table lists Dead time requirements for the module input, excluding photocoupler delays. When specifying dead time requirements for the photocoupler input, please add photocoupler delays to the dead time given above. Dead Time Timing Chart 15 V VIN Waveform 0 15 V VIN Waveform 0 tdead tdead 2004-10-01 7/9 MIG400Q2CMB1X IC - VCE 900 800 VD = 17 V 900 800 IC - VCE VD = 17 V VD = 13 V (A) (A) 700 600 500 400 300 200 100 0 0 1 2 3 700 600 500 400 300 200 100 0 Common emitter Tj = 125C 0 1 2 3 4 5 VD = 15 V VD = 13 V IC Collector current VD = 15 V Common emitter Tj = 25C 4 5 Collector-emitter voltage VCE (V) Collector current IC Collector-emitter voltage VCE (V) Switching time - IC 10 10 Switching time - IC (s) 1 (s) ton toff tc (on) tc (off) ton toff 1 tc (on) tc (off) Switching time 0.1 Tj = 25C VCC = 600 V VD = 15 V L-LOAD 0.01 0 100 200 300 400 500 Switching time 0.1 Tj = 125C VCC = 600 V VD = 15 V L-LOAD 0.01 0 100 200 300 400 500 Collector current IC (A) Collector current IC (A) IF - VF 900 800 1000 trr, Irr - IF Peak reverse recovery current Irr (A) Reverse recovery time trr (x 10 ns) Irr (A) 700 600 500 400 300 200 Common cathode 100 0 0 : Tj = 25C : Tj = 125C 1 2 3 4 Forward current IF 100 10 trr Common cathode : Tj = 25C : Tj = 125C 1 0 100 200 300 400 500 Forward voltage VF (V) Forward current IF (A) 2004-10-01 8/9 MIG400Q2CMB1X OC - Tc 1200 60 ID - fc (A) (mA) ID Control circuit current OC 1000 50 Over current protection trip level 800 40 600 30 400 20 200 VD = 15 V 0 0 10 VD = 15 V Tj = 25C 0 25 50 75 100 125 150 0 5 10 15 20 25 Case temperature Tc (C) Carrier frequency fc (kHz) Reverse bias SOA Rth (t) (C/W) 720 1 Rth (t) - tw OC 0.3 0.1 0.03 Transistor stage 0.01 Diode stage IC (A) 640 480 320 Transient themal resistance Collector current 0.003 0.001 Tc = 25C 0.0003 0.001 0.01 160 Tj < 125C = VD = 15 V 0 400 800 1200 1400 0 0.1 1 10 Collector-emitter voltage VCE (V) Pulse width tw (s) Eon - IC 100 100 Eoff - IC Eon (mJ) 10 (mJ) Turn off loss Eoff VCC = 600 V VD = 15 V L-LOAD : Tj = 25C : Tj = 125C 100 200 300 400 500 10 Turn on loss 1 1 VCC = 600 V VD = 15 V L-LOAD : Tj = 25C : Tj = 125C 0 100 200 300 400 500 0.1 0 0.1 Collector current IC (A) Collector current IC (A) 2004-10-01 9/9 |
Price & Availability of MIG400Q2CMB1X
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |