|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
AP1119 0.5A Positive Low Dropout Fixed-Mode Regulator With EN Function Features * * * * * * * General Description AP1119 is a low dropout positive adjustable or fixed-mode regulator with minimum of 0.5A output current capability. The product is specifically designed to provide well-regulated supply for low voltage IC applications such as high-speed bus termination and low current 3.3V logic supply. AP1119 is also well suited for other applications such as VGA cards. AP1119 is guaranteed to have <1.3V dropout at full load current making it ideal to provide well regulated fixed outputs of 1.5 to 12V with up to 18V input supply. The AP1119 offers a TTL - Logic compatible enable pin. 1.3V maximum dropout at full load current Fast transient response Output current limiting Built-in thermal shutdown Packages: SOT89-5L Good noise rejection 5-Terminal device with fixed 1.5V, 1.8V, 2.5V, 3.3V, 5.0V, 9.0V, 12V output. Applications * * * PC peripheral Communication CDROM.. Ordering Information AP 1119 X XX X X Low Dropout Regulator Package Y : SOT89-5L Vout 15 : 1.5V 18 : 1.8V 25 : 2.5V 33 : 3.3V 50 : 5.0V 90 : 9.0V 12 : 12V Lead Free Blank : Normal L : Lead Free Package Packing Blank : Tube A : Taping Typical Circuit 5V C1 100uF NC Tab is Vout ON OFF EN 4 3 2 Vin 3.3V/0.5A Vout GND 5 1 C2 100uF ( 5V/3.3V fixed output ) This datasheet contains new product information. Anachip Corp. reserves the rights to modify the product specification without notice. No liability is assumed as a result of the use of this product. No rights under any patent accompany the sale of the product. Rev. 1.0 Aug 20, 2004 1/5 AP1119 0.5A Positive Low Dropout Fixed-Mode Regulator With EN Function Connection Diagram 5 PIN SOT89 NC Tab is Vout EN 4 3 2 Vin Vout GND 5 1 Pin Descriptions NAME GND Vout Ground The output of the regulator. A minimum of 10uF capacitor must be connected from this pin to ground to insure stability. The input pin of regulator. Typically a large storage capacitor is connected from this pin to ground to insure that the input voltage does not sag below the minimum dropout voltage during the load transient response. This pin must always be 1.3V higher than Vout in order for the device to regulate properly. The input pin of regulator. TTL/CMOS compatible input Logic high = disable output, Logic Low or open =Enable output. (internal Pull-down resistor ~ l00K). FUNCTION Vin EN Absolute Maximum Ratings Characteristics DC Supply Voltage Power Dissipation Storage Temperature Operating Junction Temperature Range Symbol Vin PD TST TOP. Values -0.3 to 18 Internally Limited -65 to +150 0 to +150 oC oC Unit V Anachip Corp. www.anachip.com.tw 2/5 Rev. 1.0 Aug 20, 2004 AP1119 0.5A Positive Low Dropout Fixed-Mode Regulator With EN Function Electrical Characteristics (Under Operating Conditions) PARAMETER CONDITIONS o IOUT = 10mA, TJ = 25 C, AP1119-1.5 3VVIN12V o IOUT = 10mA, TJ = 25 C, AP1119-1.8 3.3VVIN12V o IOUT = 10mA, TJ = 25 C, AP1119-2.5 4VVIN12V o IOUT = 10mA, TJ = 25 C, AP1119-3.3 4.8VVIN12V o IOUT = 10mA, TJ = 25 C, AP1119-5.0 6.5VVIN12V o IOUT = 10mA, TJ = 25 C, AP1119-9.0 10.5VVIN18V o IOUT = 10mA, TJ = 25 C, AP1119-12.0 13.5VVIN18V IO=10mA,VOUT+1.5V O O Output Voltage Line Regulation Load Regulation Dropout Voltage (VIN-VOUT) Current Limit Minimum Load Current VEN IEN Thermal Regulation Ripple Rejection Temperature Stability 0.008 60 0.5 300 100 JA JC C/W C/W Note1: See thermal regulation specifications for changes in output voltage due to heating effects. Line and load regulation are measured at a constant junction temperature by low duty cycle pulse testing. Load regulation is measured at the output lead = 1/18" from the package. Note2: Line and load regulation are guaranteed up to the maximum power dissipation of 5W. Power dissipation is determined by the input/output differential and the output current. Guaranteed maximum power dissipation will not be available over the full input/output range. Note3: Quiescent current is defined as the minimum output current required maintain regulation. At 12V input/output differential the device is guaranteed to regulate if the output current is greater than 10mA. Anachip Corp. www.anachip.com.tw 3/5 Rev. 1.0 Aug 20 ,2004 AP1119 0.5A Positive Low Dropout Fixed-Mode Regulator With EN Function Typical Performance Characteristics 2. 0 1. 8 0.20 Output Voltage Deviation (%) 1. 6 0 I load=500mA Dropout Voltage (V) 1. 4 1. 2 1. 0 0. 8 0. 6 0. 4 0. 2 0 0 100 Tj = 125 oC Tj = 25 oC -0.20 -0.40 -0.80 Dropout Voltage vs Output Current 2 1.5 1 Output Current (mA) 200 300 400 500 -1 -25 0 Load Regulation vs Temperature Temperature ( oC) 25 50 75 100 125 Output Voltage Change (%) 1 0. 5 0 -0.5 -1 -1.5 -2 -50 -25 0 25 50 75 100 125 150 0.8 Output Voltage Deviation (%) 0.6 0.4 0.2 0 Percent Change in Output Voltage vs Temperature Output Voltage Deviation (mV) Input Voltage (V) Load Current (A) Output Voltage Deviation (mV) 7.5 6.5 5.5 40 20 0 -20 -40 Cin=1uF Cout=10uF Tantalum 30 20 10 0 -10 -20 2 1 0 -1 0 10 20 Temperature ( oC) 2 4 Line Regulation C in = 1uF C out = 10 uF Tantalum Preload = 100mA Input Voltage (V) 6 8 10 12 0 20 40 60 TIME (us) 80 100 120 140 160 180 200 30 Line Transient Response Anachip Corp. www.anachip.com.tw 4/5 Load Transient Response Rev. 1.0 Aug 20 ,2004 TIME (us) 40 50 60 70 80 90 100 AP1119 0.5A Positive Low Dropout Fixed-Mode Regulator With EN Function Marking Information SOT89-5L 4 5 Identification code Identification Cod ( See the table ) Blank: normal L: Lead Free Package JF JG JH JI JJ JK JL Output version AP1119-1.5V AP1119-1.8V AP1119-2.5V AP1119-3.3V AP1119-5.0V AP1119-9.0V AP1119-12V Date Code Month: A~L Year: 0~9 XX XX X 1 2 3 Package Information A C D F 1.7 0.5 E B 1.2 F 0.55 I H G 1.1 0.4 1.5 Land Pattern Recommendation (Unit: mm) L J Symbol A B C D E F G H I J K L Dimensions In Millimeters Min. Nom. Max. 4.40 4.50 4.60 4.05 4.15 4.25 1.50 1.60 1.70 1.30 1.40 1.50 2.40 2.50 2.60 0.80 3.00 Ref. 1.50 Ref. 0.40 0.46 0.52 1.40 1.50 1.60 0.35 0.39 0.43 5o Typ. K Dimensions In Inches Min. Nom. Max. 0.173 0.177 0.181 0.159 0.163 0.167 0.059 0.063 0.067 0.051 0.055 0.059 0.094 0.098 0.102 0.031 0.118 Ref. 0.059 Ref. 0.016 0.018 0.020 0.055 0.059 0.063 0.014 0.015 0.017 5o Typ. Anachip Corp. www.anachip.com.tw 5/5 4.6 Rev. 1.0 Aug 20 ,2004 |
Price & Availability of AP1119 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |